Learn · N3 · Short reading

修理後の扇風機を受け取った方へ

この袋の中には、修理した扇風機の台と、動くかどうかを調べた結果が入っています。本体は袋と別にお渡ししました。机に置いて使う前に、袋の内側の小さなポケットから短いねじを二本出し、台を本体に取り付けてください。 袋の外側のポケットにある長いねじは、古い台から外したものです。修理した台には使わないので、そのままにしておいてください。台を付けたあとで、机の上で風の強さを一度確かめてください。
English study notes

Learning objective

Identify which screws must be used to attach the fan’s repaired stand before testing the fan.

Reading help

The bag contains the fan stand that was repaired and the results of the function check. You received the fan itself separately. Before using it on your desk, take the two short screws from the small inside pocket and attach the stand to the fan. The long screws in the outside pocket came from the old stand and should stay where they are. Once the stand is attached, put the fan on the desk and check the strength of the airflow once.

Glossary

扇風機(せんぷうき)
An electric fan.
本体(ほんたい)
The main body of a device, here the fan without its stand.
ねじ(ねじ)
A screw used to hold parts together.
取り付ける(とりつける)
To fasten one part onto another.

After reading

- The bag and the fan body were handed over separately. - Attach the stand using both short screws from the small inside pocket. The longer screws are old parts kept in the outside pocket. - The desk check comes after the stand goes on. The note tells you the bag holds a test result but does not state what that result was.

Exam focus & common mistakes

• Matching the number of screws is insufficient if a choice picks the wrong pocket. Link each screw length to its pocket and purpose before comparing near-identical options. • At the end, 「あとで」 puts the airflow check on one side of assembly. Keep that check distinct from the result already packed inside the bag.

Exam practice and explanations

Exam practice

受け取った扇風機を机で使う前に、どのように台を付ければよいか。

Show answer

Answer: 3

  1. The long screws came off the old stand. The directions leave them in the outside pocket.
  2. Both usable screws come from the inside pocket. The airflow check follows assembly.
  3. 「机に置いて使う前に、袋の内側の小さなポケットから短いねじを二本出し、台を本体に取り付けてください。」 identifies the pair to use for assembly.
  4. The stand is fastened to the body with the short screws. Reading the earlier test result does not replace this assembly step.

Evidence: 机に置いて使う前に、袋の内側の小さなポケットから短いねじを二本出し、台を本体に取り付けてください。

← All N3 reading passages